1 .		A sine wave of 15 kHz is changing at a faster rate than a sine wave with a frequency of [Hint]   25 kHz   12 kHz   18 kHz   1.3 MHz
2 .		A sine wave with a period of 4 ms is changing at a faster rate than a sine wave with a period of [Hint]   0.0045 s   2 ms   1.5 ms   3,000 s
3 .		When a sine wave has a frequency of 100 Hz in 12 s it goes through [Hint]   1/100 cycle   12 cycles   120 cycles   1,200 cycles
4 .		If the peak of a sine wave is 13 V, the peak-to-peak value is [Hint]   6.5 V   13 V   26 V   none of these
5 .		If the peak value of a sine wave is 30 V, the rms value is [Hint]   19.08 V   7.07 V   0.707 V   23.10 V
6 .		The average value of a 12 V peak sine wave over one complete cycle is [Hint]   0 V   1.27 V   7.64 V   6.37 V
7 .		The average half-cycle value of a sine wave with a 40 V peak is [Hint]   25.48 V   6.37 V   14.14 V   50.96 V
8 .		One sine wave has a positive-going zero crossing at 15° and another sine wave has a positive-going zero crossing at 55°. The phase angle between the two waveforms is [Hint]   0°   45°   40°   none of these choices
9 .		If the rms current through a 6.8 k resistor is 8 mA, the rms voltage drop across the resistor is [Hint]   5.44 V   54.4 V   7.07 V   8 V
10 .		If the rms current through a 4.7 k resistor is 4 mA, the peak voltage drop across the resistor is [Hint]   4 V   18.8 V   26.6 V   2.66 V
11 .		If the rms voltage drop across a 15 k resistor is 16 V, the peak current through the resistor is [Hint]   15 mA   1.5 mA   10 mA   1 mA
12 .		Two series resistors are connected to an ac source. If there are 7.5 V rms across one resistor and 4.2 V rms across the other, the peak source voltage is [Hint]   16.54 V   1.65 V   10.60 V   5.93 V
13 .		A 20 kHz pulse waveform consists of pulses that are 15 s wide. The duty cycle is [Hint]   1%   30%   100%   cannot be determined
14 .		A pulse wave form has a high time of 8 ms and a pulse width of 32 ms. The duty cycle is [Hint]   25%   50%   1%   100%
15 .		A signal with a 400 s period has a frequency of [Hint]   250 Hz   2,500 Hz   25,000 Hz   400 Hz
16 .		If a sine wave goes through 10 cycles in 20 s, the period is [Hint]   20 s   4 s   2 s   100 s
17 .		The conductive loop on the rotor of a simple two-pole, single-phase generator rotates at a rate of 400 rps. The frequency of the induced output voltage is [Hint]   40 Hz   100 Hz   400 Hz   indeterminable
18 .		To produce an 800 Hz sine wave, a four-pole generator must be operated at [Hint]   200 rps   400 rps   800 rps   1,600 rps
19 .		A sinusoidal current has an rms value of 14 mA. The peak-to-peak value is [Hint]   45.12 mA   16 mA   39.6 mA   22.6 mA
20 .		How many degrees are there in /3 rad? [Hint]   6°   60°   180°   27°
21 .		Sine wave A has a positive-going zero crossing at 45°. Sine wave B has a positive-going zero crossing at 60°. Which of the following statements is true? [Hint]   wave A leads wave B by 15°   wave A lags wave B by 15°   wave A leads wave B by 105°   wave A lags wave B by 105°
22 .		A sine wave with an rms value of 12 V is riding on a dc level of 18 V. The maximum value of the resulting waveform is [Hint]   6 V   30 V   35 V   0 V
23 .		A waveform has a baseline of 3 V, a duty cycle of 20 %, and an amplitude of 8 V. The average voltage value is [Hint]   4 V   4.6 V   1.6 V   11 V
24 .		A sawtooth wave has a period of 10 ms. Its frequency is [Hint]   10 Hz   50 Hz   100 Hz   1,000 Hz
25 .		A square wave has a period of 60 s. The first odd harmonic is [Hint]   5 kHz   50 kHz   500 kHz   33.33 kHz